14 Safety Notes
When the product is left in a chilly room and
the room is rapidly warmed up by heater,
dew condensation may form inside the
product and cause a partial deletion on
printing.
Operational Safety
The operator's product maintenance
procedures are described in the customer
documentation supplied with this product.
Do not carry out any other maintenance
procedures not described in the
documentation.
This product features safety design not to
allow operators access to hazard areas.
The hazard areas are isolated from
operators by covers or protectors which
require a tool to remove. To prevent electric
shock and injuries, never remove those
covers and protectors.
To avoid the risk of electric shock and a fire
accident, switch off and unplug the product
promptly in the following conditions, then
contact your local Fuji Xerox
representative.
• The product emits smoke or its surface is
unusually hot.
• The product emits unusual noise or odor.
• The power cord is cracked or worn down.
• A circuit breaker, fuse or any other safety
device is activated.
• Any liquid is spilled into the product.
• The product is soaked in water.
• Any part of the product is damaged.
Do not insert any object into slots or
openings of this product.
Do not place any of the followings on the
product:
• Liquid container such as flower vases or
coffee cups
• Metal parts such as staples or clips
• Heavy objects
If liquid is spilled over or metal parts are
slipped into the product, it may cause
electric shock or a fire accident.
Do not use conductive paper such as
origami paper, carbonic paper or
conductively-coated paper. When paper
jam occurs, it may cause short-circuit and
eventually a fire accident.
When cleaning this product, use the
designated cleaning materials exclusive to
it. Other cleaning materials may result in
poor performance of the product. Never
use aerosol cleaners, or it may catch fire
and cause explosion.
If you need to pull out a tray to remove
paper jam, contact your local Fuji Xerox
representative. Do not pull out a tray,
otherwise it may cause injuries.
Never play the CD-ROM supplied with the
product on an audio player. Always use a
CD-ROM player. Otherwise, large sound
may damage audio players or your ears.
Laser Safety
: Any operations or
adjustments not stated in the operation
manual may cause hazardous light
exposure and eventually burn injuries or
loss of eyesight.
This product has been tested and found to
comply with the Class 1 Laser Equipment
requirements defined by the international
standard IEC60825 and has no light
exposure hazard. The product has no
hazardous light emission as it features light
protection components and covers to shut
in all light beam during operation and
maintenance.
Always follow all warning instructions
marked on or supplied with this product.
To avoid the risk of burn injuries and
electric shock, never touch the area with
the "High Temperature" or "High Voltage"
marks on.
Keep electrical and mechanical safety
interlocks active. Keep the safety interlocks
away from magnetic materials. Magnetic
materials may accidentally activate the
product and cause injuries or electric
shock.
To Next Page
Loading...
