Xerox Phaser 3160B User Manual

Troubleshooting_59
Background
scatter
Background scatter results from bits of toner
randomly distributed on the printed page.
• The paper may be too damp. Try printing
with a different batch of paper. Do not open
packages of paper until necessary so that
the paper does not absorb too much
moisture.
• If background scatter occurs on an envelope,
change the printing layout to avoid printing
over areas that have overlapping seams on
the reverse side. Printing on seams can
cause problems.
• If background scatter covers the entire
surface area of a printed page, adjust the
print resolution through your software
application or in Printing Preferences. (See
"Opening printing preferences" on page 38.)
Misformed
characters
• If characters are improperly formed and
producing hollow images, the paper stock
may be too slick. Try different paper. (See
"Print media specifications" on page 66.)
Page skew
• Ensure that the paper is loaded properly.
• Check the paper type and quality. (See "Print
media specifications" on page 66.)
• Ensure that the guides are not too tight or too
loose against the paper stack.
Curl or wave
• Ensure that the paper is loaded properly.
• Check the paper type and quality. Both high
temperature and humidity can cause paper
curl. (See "Print media specifications" on
page 66.)
• Turn the stack of paper over in the tray. Also
try rotating the paper 180° in the tray.
CONDITION SUGGESTED SOLUTIONS
A
AaBb
C
AaBb
C
AaBb
C
AaBbC
AaBbC
c
Wrinkles or
creases
• Ensure that the paper is loaded properly.
• Check the paper type and quality. (See "Print
media specifications" on page 66.)
• Turn the stack of paper over in the tray. Also
try rotating the paper 180° in the tray.
Back of printouts
are dirty
Check for leaking toner. Clean the inside of the
machine. (See "Cleaning the inside" on
page 50.)
Solid Color or
Black pages
• The toner cartridge may not be installed
properly. Remove the cartridge and reinsert it.
• The toner cartridge may be defective.
Remove the toner cartridge and install a new
one. (See "Replacing the toner cartridge" on
page 62.)
• The machine may require repair. Contact a
service representative.
Loose toner
• Clean the inside of the machine. (See
"Cleaning the inside" on page 50.)
• Check the paper type and quality. (See "Print
media specifications" on page 66.)
• Remove the toner cartridge and then, install a
new one. (See "Replacing the toner cartridge"
on page 62.)
• If the problem persists, the machine may
require repair. Contact a service
representative.
Character Voids
Character voids are white areas within parts of
characters that should be solid black:
• If you are using transparencies, try another
type of transparency. Because of the
composition of transparencies, some
character voids are normal.
• You may be printing on the wrong surface of
the paper. Remove the paper and turn it
around.
• The paper may not meet paper
specifications. (See "Print media
specifications" on page 66.)
CONDITION SUGGESTED SOLUTIONS
A
A

Xerox Phaser 3160B Specifications

General

Brand	Xerox
Model	Phaser 3160B
Category	Printer
Language	English