Control Panel Error Messages
Phaser® 6180 Color Laser Printer
7-24
Paper JAM
Paper is jammed inside the printer.
Press the button to open the front cover and remove the jammed
paper. See Paper Jams on page 7-2.
RAM Disk Full
Press Set
RAM disk memory is full and cannot continue processing the
current print job.
Press the OK button to clear the message, cancel the current print
job, and conduct the next print job, if any.
Press the Cancel button to cancel the print job.
Press the Left Arrow button to open the Walk-Up Features
menu and delete the current job.
To avoid this error in the future, do the following:
Reduce the number of print pages, such as splitting the print
data.
Increase free memory space by deleting unnecessary data in
the RAM disk.
Ready to Print
142-700
Over Heat
Turned Halfmode
The printer’s internal temperature is too high.
Processing on the printer has been slowed down. When the
internal temperature falls, the processing speed will automatically
increase.
Ready to Print
Non-GenuineToner
The printer is in the custom toner mode.
Though some of the print cartridges reach the end of their lives,
you can continue printing.
Reboot Printer
NNN-NNN
Error NNN-NNN relates to printer problems.
Turn the printer off and then on. If the error continues, refer to the
Xerox Support website, www.xerox.com/office/6180support.
Reboot Printer
116-NNN
Error NNN-NNN relates to printer problems.
Turn the printer off and then on.
Reboot Printer
NNN-NNN
The Multi-Protocol Network Card (optional) is not installed
correctly or is not working correctly due to damage or malfunction.
Reinstall the Multi-Protocol Network Card.
Reboot Printer
072-215
The 550-Sheet Feeder (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the sheet feeder.
Reboot Printer
077-215
The Duplex Unit (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the Duplex Unit.
Reboot Printer
116-316
Additional memory (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the additional memory.
Reboot Printer
116-320
An unsupported additional memory (optional) is installed.
Replace the specified additional memory.
Message Condition/Reason/Action
To Next Page
Loading...
