Xerox Phaser 6180 - Page 98

Description of Menu Items
Phaser® 6180 Color Laser Printer
5-10
Parallel Setup
Specifies the settings for the parallel interface.
Note: You need to restart the printer to activate the new settings. After making the settings,
turn off the printer and then turn it on again.
System Setup
System Setup menu is used to make the printer operation settings, such as for alarm and power
saver mode.
Item Description
Bi-directional Specifies the Bi-directional communication mode of the parallel interface.
■ Enable (default)
The Bi-directional communication mode is enabled.
■ Disable
The Bi-directional communication mode is disabled.
Item Description
PowerSaver
Timer
Specify the transitional time to Power Saver between 5 and 60 minutes in
increments of 1 minute.
■ 5 min. to 60 min. (default: 30 min.)
■ For details, refer to Power Saver Mode on page 2-8
Audio Tone Specifies whether to turn on the alarm when an error occurs in the printer. You
cannot adjust the sound volume.
■ Control Panel (default: Off)
■ Invalid Key (default: Off)
■ Machine Ready (default: Off)
■ Job Complete (default: Off)
■ Fault Tone (default: Off)
■ Alert Tone (default: Off)
■ Out of Paper (default: Off)
■ Low Toner Alert (default: Off)
■ Base Tone (default: Off)
Time-Out You can cancel a printing process when it goes beyond a set time period. Set the
time until the print job is canceled. When this timeout expires, the print job is
canceled.
■ 5 sec. to 300 sec. (default: 30 sec.)
Specifies the amount of time in increments of 1 second the printer waits for
additional data before it cancels the job.
■ Off
Cannot cancel.