Xerox Phaser 7760 Advanced Features Guide

Printer Settings
Phaser® 7760 Color Laser Printer
4-14
Setting the Default Paper Destination
The printer has one output tray located on the top of the printer. If a finisher is installed, the
following output options are available:
■ Top output tray (horizontal transport)
■ Finisher upper output tray
■ Finisher stacker output tray
■ Finisher booklet output tray
Note: If you select stapling or hole punching in the printer driver, the output automatically
goes to a finisher output tray.
To select the default Paper Destination setting, use one of the following options:
■ The printer’s control panel
■ CentreWare IS
Using the Control Panel
To select the default Paper Destination in the control panel:
1. Select
Printer Setup, and then press the OK button.
2. Select
Paper Handling Setup, and then press the OK button.
3. Select
Paper Destination, and then press the OK button.
4. Select the appropriate tray, and then press the OK button.
Using CentreWare IS
To select the default Paper Destination using CentreWare IS:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select General on the left sidebar, and then select Printer Defaults.
5. Select the appropriate tray in the Output Tray drop-down list.
6. Click Save Changes at the bottom of the page.

Xerox Phaser 7760 Specifications

General

Brand	Xerox
Model	Phaser 7760
Category	Printer
Language	English