Xerox Phaser 8860 System Administrator Guide

Configuring SNMP
System Administrator Guide
4-22
Configuring the SNMP Access Control List
To set up a list of hosts that are authorized to access the printer using SNMP:
1. Launch your web browser.
2. Enter your printer’s IP address in the browser’s Address field.
3. Click Properties.
4. Select the Protocol folder on the left navigation panel.
5. Select SNMP.
6. If prompted, enter your Admin or Key User name and password.
7. Enter up to ten host IP addresses in the SNMP Access Control List field. Separate entries
with a blank or a comma, specify ranges with a hyphen (-), and use an asterisk (*) to
represent a group of numbers (e.g., 13.62.156.*).
8. Click the Save Changes button.
See also:
About Access Control Lists on page 4-4

Xerox Phaser 8860 Specifications

General

Brand	Xerox
Model	Phaser 8860
Category	All in One Printer
Language	English