System Administrator Guide
B-4
Input Trays
The following table lists the PCL commands for the input trays supported by the
Phaser 8860MFP multifunction printer. The table also lists the alternate tray used if the
optional input tray is not installed.
Note: When more than one command is listed, you can use either command.
Input Trays PCL 5 Command
*
Alternate Tray
Tray 1 in multi-sheet mode <Esc>&l4H
<Esc>&6H
n/a
Tray 1 in manual feed mode <Esc>&l2H
<Esc>&l3H
n/a
Tray 2 <Esc>&l1H n/a
Tray 3 <Esc>&l5H Tray 2
Tray 4 <Esc>&l8H
<Esc>&l20H
Tray 1
Autoselect <Esc>&l7H n/a
Current tray/page eject <Esc>&l10H n/a
* The character that follows the “&” in the command is the lowercase letter “L”.
To Next Page
Loading...
Need help?
General
