Cleaning the Printer
CClleeaanniinngg tthhee EExxtteerriioorr
Clean the exterior of the printer once a month.
• Wipe the paper tray, output tray, control panel, and other parts with a damp, soft cloth.
• After cleaning, wipe with a dry, soft cloth.
• For stubborn stains, apply a small amount of mild detergent to the cloth and gently wipe the stain
off.
Caution: Do not spray detergent directly on the printer. Liquid detergent could enter the printer
through a gap and cause problems. Never use cleaning agents other than water or mild
detergent.
CClleeaanniinngg tthhee IInntteerriioorr
WARNING: Never touch a labeled area on or near the heat roller in the fuser. You can get
burned. If a sheet of paper is wrapped around the heat roller, do not try to remove it
immediately. Power off the printer immediately and wait 40 minutes for the fuser to cool. Try
to remove the paper jam after the printer has cooled.
To prevent stains inside the printer that can deteriorate print quality, clean the interior of the printer
regularly. Clean the printer interior whenever you replace a drum cartridge.
After clearing paper jams or replacing a toner cartridge, inspect inside the printer before closing the
printer covers and doors.
• Remove any remaining pieces of paper or debris.
• Remove any dust or stains with a clean, dry, lint-free cloth.
Xerox
®
VersaLink
®
C600 Color Printer
User Guide
127
Maintenance
To Next Page
Loading...
Need help?
General