Xerox WorkCentre 5632 System Administrator Guide

Network Configuration
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
105
• Printer Traps
• Job Monitoring Traps
• Cold Start Generic Traps
• Warm Start Generic Traps
• Authentication Failure Generic Traps (Status: Enabled)
Note: When Authentication Failure Generic Traps is disabled, traps of this type will not be sent
by this device. To enable Authentication Failure Generic Traps, go to SNMP Properties from the
main SNMP Configuration page.
8. Click on the [Save] button to save settings and return to the Advanced Settings page.
9. Click on the [Back] button to return to the SNMP page.
10. Click on the [Apply] button to accept the changes or [Undo] to return the settings to their
previous values.
11. Click on the [OK] button when you see the message “Properties have been successfully
modified”.
To Add or Edit an IPX Address:
The System Administrator uses this page to add or edit an Internetwork Packet Exchange (IPX) trap
destination address for this printer. IPX is a routing protocol used in Novell NetWare environments.
Default values are shown when adding an address.
1. From the SNMP page, click on the [Advanced Settings] button.
2. To add an IPX Address or edit, in the Trap Destination Addresses area, click on the [Add IPX
Address] button or the [Edit] button for the required address.
3. In the Required Information area:
a. For [IPX External Network Number], enter the IPX number of the device that is set to receive
traps.
b. For [Physical MAC Address], enter the MAC address of the printer that is receiving the trap.
c. For [IPX Socket Number], enter the socket number of the running application that is
listening for the information.
d. For [SNMP Version], select the SNMP version that matches the SNMP manager with which
the device is communicating.
4. In the Traps area:
a. The [TRAP Community Name] will display the default value for the TRAP Community Name.
b. For [Traps to be Received], check the checkbox for the type of traps sent by this device to the
Destination Address indicated by the IP Address and UDP port number entered by the user.
The choices are:
• Printer Traps
• Job Monitoring Traps
• Cold Start Generic Traps
•
Warm Start Generic Traps

Xerox WorkCentre 5632 Specifications

General

Brand	Xerox
Model	WorkCentre 5632
Category	All in One Printer
Language	English