Network Configuration
WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
134
• [Remote System Name: hostname]. Where hostname is the machine hostname from the
/etc/hosts file.
• Select [Remote Printer is on a BSD System] and click on [OK] to complete form.
9. Click on [Yes] at the Configure HP UX Printers Subpanel screen. This screen may be obscured by
the Add Remote Printer/Plotter form.
10. Select [File: Exit].
11. Select [File: Exit Sam].
12. Type [exit] to exit super user mode.
13. Test the queue created. Type the command [lp -d queuename /etc/hosts].
tty Method
Follow the steps below to use the HP System Administrator Manager (SAM) GUI (Graphical User
Interface).
Note: Refer to the HP-UX documentation for additional information on using the System
Administrator Manager (SAM).
1. Open a command window on the desktop. From the command prompt (#), enter the information
below. Remember that UNIX commands are case-sensitive.
2. Type [su] to become super user.
3. Type [sh] to run the Bourne shell.
4. Type [lpshut] to stop the print service.
5. Create the print queue by typing (on the same command line): [lpadmin -pqueuename -
v/dev/null -mrmodel -ocmrcmodel -osmrsmodel -ob3 -orc -ormhostname -orplp].
Where queuename is the name of the queue being created and hostname is the machine
hostname from the /etc/hosts file.
6. Type [lpsched] to start the print service.
7. Type [enable queuename] to enable the queue to print to the machine.
8. Type [accept queuename] to the queue accepting jobs from the HP-UX workstation.
9. Type [exit] to exit the Bourne shell and then [exit] to exit super user mode.
10. Test the queue created. Type the command [lp -d queuename /etc/hosts].
11. Verify that the job is printed at the device.
To Next Page
Loading...
Need help?
General
