Installation
Xerox® Smart Card
Installation Guide
18
6. Enter the Domain Controller details
for the authentication server.
a. Determine how many Domain
Controllers used in your
environment need to be
accessed from the particular
device.
b. Identify the order the Domain
Controllers should be
interrogated when users present
their card for authentication. The
Domain Controller which services
most of your users should be first followed by less popular Domain Controllers.
c. Enter the controllers in the preferred search order.
Note: The search order can be modified at a later date.
d. Select Add.
e. Ensure the Domain Controller
Type is configured correctly for
your authentication
environment.
f. Enter the IP Address or enter the
Domain Controller Host Name
(this must be the fully qualified
Host Name).
g. Ensure Port 88 is selected unless
your Kerberos Port is different.
h. Enter the Domain Name (this
must be the fully qualified Domain Name).
i. Select Save.
If you selected the option that the Domain Controller Signature must match the uploaded
Domain Controller Certificate, then a field will be presented to enter that certificate. This field will
be missing if it is not required to upload the Domain Controller Certificate.
j. At the Domain Controller Certificate option select Add and browse to the Domain Controller
Certificate.
Note: If you are unable to obtain the required certificates, refer to Retrieving the Certificate from a
Domain Controller or OCSP Server on page 39.
k. Select the Certificate then select Upload Domain Controller Certificate.
To Next Page
Loading...
Need help?
General
