Security
WorkCentre 7425/7428/7435
System Administrator Guide
66
Note: FQDN requires DNS and SMB Host Name requires WINS to be enabled on the printer.
13. Enter the IP Address, FQDN, or SMB host name of the domain controller (up to 64 characters) in
the SMB Server 1 Server Name / IP Address box (if By Domain Name and Server Address / IP
Address was selected for SMB Server Setup).
14. Enter the IP Address, FQDN, or SMB host name of up to 4 additional SMB servers, if applicable.
Note: FQDN requires DNS and SMB Host Name requires WINS to be enabled on the printer.
15. Click Apply.
Configure Remote Authentication for LDAP
1. Set up the LDAP Server. For information about setting up an LDAP server, see LDAP Server
Configuration on page 106.
2. Open your Web browser and enter the IP address of the printer in the address field. Press Enter to
open CentreWare Internet Services.
3. Click the Properties tab.
4. Enter the system administrator User Name and Password (default admin, 1111) if prompted.
5. Click the Security folder.
6. Click the Remote Authentication Servers folder. Enter your user name and password at the
prompt (default: admin, 1111).
7. Click Authentication System and pick LDAP from the Authentication System Settings drop down
list.
8. Enter the Server Response Time-Out, and the Search Time-Out.
9. Select the Enabled check box next to Assign UPN (User Principal Name) if desired.
10. Click Apply, and click Reboot Machine.
LDAP User Mappings
You can click LDAP User Mappings to specify the attributes to search for within the LDAP database.
For more information about LDAP user mappings, see LDAP User Mappings on page 108.
LDAP Authentication
To set LDAP for authentication, click LDAP Authentication. For Authentication Method, choose either
Direct Authentication or Authentication of User Attributes. Direct Authentication uses the user name
and password entered by the User for authentication with the LDAP server. Authentication of User
Attributes allows you to specify the what is entered by the user (Attribute of Typed User Name) and
what is used by the device (Attribute of the Login User Name) to authenticate the user. If Use Added
Text String is enabled (default disabled), then what ever text is entered in the Text String Added to User
Name box is added to the user input prior to authentication.
Knowledge of LDAP Server authentication requirements and capabilities are required to properly
configure these settings.
To Next Page
Loading...
Need help?
General
