11
9.5.1 Setup:Send SMS stockade+password+space+latitude,longitude;latitude,longitude
to the unit to set the restricted district.
Remark :The first latitude&longitude is coordinate of the top left corner of the Geo-fence,
while the second latitude&longitude is the coordinate of the bottom right corner.
9.5.2 Cancel:Send SMS nostockade+password to deactivate this function..
9.5.3 Response SMS format: stockade!+geo-info. It will alarm one time in each setting.
9.6
Movement
Alert
This function is using for the owner to get alarm when the tracker
moves
out
of
a
restricted
district.
9.6.1
Setup:
Send
SMS
move+password
to
the
unit
to
set
the
movement
alert.
9.6.2
Cancel:
Send
SMS
nomove+password
to
deactivate
the
movement
alert.
This
function
will
be
out
of
effect
after
the
unit
moves
outside
the
district.
Response
SMS
format:
move!+geo-info.
It
will
alarm
one
time
in
each setting.
9.7 Overspeed Alert:
This function is using for the owner to control the target’s speed.
9.7.1 Setup: Send SMS speed+password+space+080 to the unit (suppose the speed is
80km/h), and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the
unit will send SMS speed+080!+Geo-info to the authorized numbers.
It
will
keep
sending
such
an
alert
every
3
minutes.
9.7.2 Cancel: Send SMS nospeed+password to deactivate the overspeed alert
Remark: It is recommended that the speed alarm is set at not less than 50km/h. For
below that rate, it may cause the excursion of the GPS signal influenced by clounds etc.
Response SMS format: speed+080!+Geo-info (suppose the speed is 80km/h).
To Next Page
Loading...
