XHDATA D-808 - MW (medium wave)

14
To receive MW broadcasts, press the LW/MW buon. Here are your tuning op-
ons.
1. Press FREQ, enter the frequency of the staon, either 3 or 4 digits.
2. Long press the LW/MW buon to acvate ATS and store all strong staons
into memory (see secon on the Memory system for how to access them).
3. Press the up or down arrow keys to go to the next frequency.
4. Long press the up or down arrow to scan for the next strong staon.
5. Rotate the tuning knob to tune staons.
Rotate the radio for the best recepon. Refer to the Antenna topic for more infor-
maon.
LW (longwave)
Longwave recepon is not enabled from the factory. Refer to the Sengs topic for
how to enable it. Pressing the LW/MW buon when longwave is enabled switches
between the two bands. The display shows which is selected.
Here are your tuning opons.
1. Press FREQ, enter the frequency of the staon.
2. Long press the LW/MW buon to acvate ATS to store all strong staons into
memory (see Memory system topic for how to access them).
3. Press the up or down arrow keys to go to the next frequency.
4. Long press the up or down arrow to scan for the next strong staon.
5. Rotate the tuning knob to tune staons.
Rotate the radio horizontally for the best recepon. Refer to the Antenna topic for
more informaon.