XHDATA D-808 - SW (shortwave)

15
SW (shortwave)
Fully extend the whip antenna and press the SW buon to selects the shortwave
funcon and tune to the previously accessed shortwave frequency. Repeated press-
es of the buon cycle through the 14 internaonal shortwave broadcast bands The
display shows which meter band is selected briey aer the buon is pressed. The
bands are:
• 120m (2300 - 2495kHz)
• 90m (3200 - 3400 kHz)
• 75m (3900 - 4000 kHz)
• 60m (4750 - 4995 kHz)
• 49m (5730 - 6200 kHz)
• 41m (7100 -7450 kHz)
• 31m (9250 -9900 kHz)
• 25m (11500 - 12100 kHz)
• 22m (13570 - 13870 kHz)
• 19m (15300 - 15830 kHz)
• 16m (17480 - 17900 kHz)
• 15m (18900 - 19020 kHz)
• 13m (21450 - 21850 kHz)
• 11m (25670 - 26100 kHz)
Note: The band ending frequencies are approximate.
Here are your tuning opons.
1. Press FREQ and enter the frequency of the staon. You may need to press FREQ
again to complete.
2. Long press the SW buon to acvate ATS to store all strong staons into
memory (see Memory System topic for how to access them). Note that only the
staons within the 14 internaonal shortwave bands are scanned.