XHDATA D-808 - Options and setup

9
Charging the radio
To charge the radio, plug a USB-C cable (included) into the USB jack on the right
side of the radio. (Some early versions of the radio use a USB Micro connector.) The
baery icon will cycle while the radio is charging. Charging will stop when the
baery is fully charged or aer 10 hours, whichever is rst. Note: some early ver-
sions of the radio may require long pressing the SSB buon to begin charging.
Opons and setup
FM Tuning range
The radio can be set for dierent tuning ranges that are convenient for FM broad-
casng in dierent regions of the world. With the radio o, long-press the FM
buon. The current seng, showing the lowest frequency of the band, is displayed.
To change the seng, press the FM buon again to cycle through the three op-
ons:
• 64.0 MHz
• 76.0 MHz
• 87.5 MHz
Longwave
The LW band is not enabled by default. To enable it, turn the radio o and long-
press the LW/MW buon. The radio will display the current status of the seng,
“LW ON” or “LW OFF.” To change the seng, press the LW /MW buon. When LW
is on, pressing the LW/MW selects either LW or MW. When it is o, the LW opon
is not available.
Medium Wave Step
The tuning step for medium wave (MW) can be set for 9 kHz or 10 kHz. To change
the seng, turn the radio o and long-press the 9/10 kHz buon (0). The current
seng is displayed. Press the buon again to cycle through the two opons. 10 kHz
us used in the Americas and 9 kHz in the rest of the world.
Beep
The radio as it comes from the factory beeps aer each key press. To disable this,
turn the radio o and long-press the BEEP buon (5). Unlike other opons, mulple