XIEGU X108G User Manual (English)

Other manuals for XIEGU X108G

Operating Manual17 pages

Service Manual36 pages

Questions and Answers:

L
Lisa HuertaJul 27, 2025
Why is my XIEGU X108G not transmitting?
- B
  Brittany PriceJul 27, 2025
  There could be several reasons why your XIEGU Transceiver is not transmitting: * The antenna might not be properly connected; ensure it is securely connected. * The power supply voltage may be too low; consider replacing the power supply. * There might be a lack of power; replace the power supply. * The antenna SWR value might be too large; check the antenna. * The work mode might not be correct; choose the right mode of work. * If none of these solve the issue, the device may need repair.
J
jason20Aug 2, 2025
What to do if my XIEGU X108G Transceiver is unable to turn on?
- D
  Danielle WagnerAug 2, 2025
  If your XIEGU X108G Transceiver is unable to turn on, consider the following: * Ensure the power cable is properly connected. * Verify that the power is turned on. * Check the power cable connection; replace or repair if bad. * Confirm the power supply is properly connected, not reversed.
T
travis83Aug 8, 2025
What to do if my XIEGU X108G Transceiver is not receiving?
- A
  Amanda WattsAug 8, 2025
  If your XIEGU Transceiver is not receiving, check the following: * Ensure the antenna is properly connected. * The antenna may be faulty; replace or repair the antenna. * Confirm the propagation characteristics of the current wave. * If none of these steps work, the device may need repair.
R
Rachel OrtizAug 13, 2025
Why is my XIEGU Transceiver screen showing no display?
- J
  Jonathan BrownAug 14, 2025
  If your XIEGU Transceiver screen shows no display, the possible causes are: * The power cord might not be connected, ensure it is properly connected. * The power might not be turned on, make sure to turn it on. * If the above steps do not resolve the issue, the device may need repair.
V
Vanessa GomezAug 20, 2025
Why is my XIEGU X108G Transceiver microphone operation an exception?
- J
  Jeremy GibsonAug 20, 2025
  If you are experiencing a microphone operation exception with your XIEGU Transceiver, consider the following: * Check the PTT interface connection; try reconnecting the microphone. * Confirm that the current frequency is not in the forbidden band; reset the frequency. * If the button has no reaction, try reconnecting the microphone. * If the issue persists, the device may need repair.

XIEGU X108G Specifications

General

Display	LCD
Modes	SSB, CW, AM, FM
Tuning Steps	10Hz
Power Supply	13.8V DC
Operating Modes	Half-duplex
Mode	SSB, CW, AM, FM
Receiver Sensitivity	0.5 µV
Interface	USB