Xilinx SmartLynq Plus User Manual

14. A new window pops up. Congure the network interface as follows and click OK.
15. You should now be able to access the SmartLynq+ Module at 10.0.0.2
Linux USB 3.0 Setup
Run the ifconfig command to congure the network interface on the IP address Linux
assigned to the SmartLynq+ Module. Linux assigns the IP address as 10.0.0.2. Run ifconfig to
view the currently acve network interfaces on this system. For example:
eth0 Link encap:Ethernet HWaddr D7:45:89:22:88:97
inet addr:172.19.3.148 Bcast:172.19.3.255 Mask:255.255.252.0 UP
BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2278375690 errors:0 dropped:307 overruns:0 frame:0 TX
packets:2305014867 errors:0 dropped:22 overruns:0 carrier:0 collisions:0
txqueuelen:1000
RX bytes:1026403610964 (955.9 GiB) TX bytes:1048839754879 (976.8
GiB)
Interrupt:17
lo Link encap:Local Loopback
Chapter 4: USB 3.0 Host Connection
UG1514 (v1.0) March 8, 2021 www.xilinx.com
SmartLynq Module+ 16
Send Feedback

Xilinx SmartLynq Plus Specifications

General

Brand	Xilinx
Model	SmartLynq Plus
Category	Network Hardware
Language	English