Xilinx SmartLynq Plus

Changing the USB 3.0 IP Setting
To change the default USB 3.0 IP address seng on the SmartLynq+ Module you rst need to set
up the host to communicate using the 10.0.0.2 IP default address. To change the IP address,
connect the host to the module using ssh on the host machine and passing in the IP address
10.0.0.2. When prompted for a user name and password, enter in the default user name xilinx
with the password xilinx.
Aer logging into the SmartLynq+ Module, run the following command to edit the USB network
sengs:
sudoedit /etc/systemd/network/20-usb-gadget.network
This command brings up a linux nano editor where you can adjust the sengs as needed. The
following are the default sengs:
[Match]
Name=usb0
[Network]
Address=10.0.0.2/24
Gateway=10.0.0.1
Reset the SmartLynq+ Module to update the USB interface.
Chapter 4: USB 3.0 Host Connection
UG1514 (v1.0) March 8, 2021 www.xilinx.com
SmartLynq Module+ 18
Send Feedback