Xilinx Virtex-7 FPGA VC7203 Characterization Kit IBERT - Attach the GTX Quad Connector

10 www.xilinx.com VC7203 IBERT Getting Started Guide
UG847 (v4.0) November 6, 2013
Chapter 1: VC7203 IBERT Getting Started Guide
Attach the GTX Quad Connector
Before connecting the BullsEye cable assembly to the board, firmly secure the blue
elastomer seal provided with the cable assembly to the bottom of the connector housing if
it is not already inserted (see Figure 1-4).
Note:
Figure 1-4 is for reference only and might not reflect the current version of the connector.
Attach the Samtec BullsEye connector to GTX Quad 115 (Figure 1-5), aligning the two
indexing pins on the bottom of the connector with the guide holes on the board. Hold the
connector flush with the board and fasten it by tightening the two captive screws.
X-Ref Target - Figure 1-4
Figure 1-4: BullsEye Connector with Elastomer Seal
X-Ref Target - Figure 1-5
Figure 1-5: BullsEye Connector Attached to Quad 115
8*BFBB
8*BFBB
Send Feedback