Xilinx Virtex-7 FPGA VC7203 Characterization Kit IBERT - Page 30

30 www.xilinx.com VC7203 IBERT Getting Started Guide
UG847 (v4.0) November 6, 2013
Chapter 1: VC7203 IBERT Getting Started Guide
7. A Customize IP window opens. In the Protocol Definition tab, change
LineRate (Gbps) to 12.5, then use the drop-down to change the Refclk (MHz) to
156.250. Do not change the other defaults (Figure 1-24).
X-Ref Target - Figure 1-24
Figure 1-24: Customize IP - Protocol Definition
8*BFBB
Send Feedback