9-3．Operated by HMI
User can change the mapping relation by XCP Pro, but PLC must be online with PC. We suggest
users to change the mapping relation by HMI. Below is the sample:
There are two screens based on ID60004 and ID60005 in XINJE TP series HMI, they are used to
changing the mapping relation of input and output. We just need to put the “Screen Jump”
Button in the program interface, touch the Button, jump to the specified screen, and change the
mapping relation there.
Modify the input point mapping diagram (HMI screen No.60004), see below:
Modify the output point mapping diagram (HMI screen No.60005), see below:
From the above graph, we can see that in the screen we list all the input/output terminals, and it’s
simple to modify. Below we tell the steps:
To Next Page
Loading...
Need help?
General
