384
Example
Asynchronous motor drives the conveyor to transfer the work piece. It needs to real-time
display the work piece moving speed. The diameter of the transmission shaft is 100mm, the
gear numbers on the transmission shaft are 100, the speed unit is m/min.
Component explanation:
Proximity switch, to count the gear numbers
Speed register (float number)
Program:
Program explanation:
1. Set ON the start signal M0, to run the frequency meansurement program
2. Transform the frequency to float number, then it is divided by 100 (gear numbers per
tudonghoatoancau.com
To Next Page
Loading...
