Xinje XL Series - Page 398

397
FEND
I4010
IRET
DI
EI
EI
SM070
FEND
I4020
IRET
END
M0
function is only supported
by PLC firmware version
V3.4.6 or later.
I49**
SM079
I59**
SM089
 Timing interruption is usually on ‘allow’ status.

Can set interruption allow and forbidden area with EI
、
DI instructions. As shown in
below pictures, all timing interruptions are forbidden between DI and EI, and
allowed beyond DI~EI.
Interruption allowed
Interruption allowed
Interruption forbidden
Interruption forbidden
Interruption
Allowed
Interruption
Program

The first 3CH timing
interruptions are equipped with
special relays (SM070~SM079).

In the left example, if use M0
to set SM070 “ON”, then forbid
timing interruption forbidden.
Interruption range’s limitation
Interruption Forbidden
tudonghoatoancau.com