8. Maintenance
180
Check Motor coolant
The motor cooling system is filled with coolant when the
vehicle leaves the factory and the coolant level should be
checked during the specified maintenance period.
Check the level markings on the side of the coolant reservoir:
►
MAX: Upper limit marker
►
MIN: Lower limit marker
The coolant level should be between the MIN mark and the
MAX mark. If it is below the MIN mark, add coolant approved
by XPENG promptly.
Refill the coolant
Unscrew the reservoir cap and fill it with coolant.
►
To maximize the performance and life of the
motor, a specific type of coolant should be
selected accordingly for the cooling system (with
dierent freezing points depending on the lowest
temperature in the location).
►
After adding coolant, promptly check the system for
leaks at your local authorized service center.
To Next Page
Loading...
Need help?
General
