52
2. Pre-Use Preparation (Interior Equipment)
Daytime Running Lights
─
When the vehicle is in READY state, the vehicle gear is not
in P gear and the close light and turn signal are off, the
daytime running light is on. If the turn signal is turned
on, the daytime running light on the corresponding side
is temporarily off, and will be re-lit after the turn signal is
turned off.
High Beam
─
With the low beam on, flip the combination switch
forward/backward to turn on/off the high beam;
─
Continuously flip the switch backward and release it, the
high beam will flash to alert the preceding vehicle or give
a sign.
Note
●
When the high beam is malfunctioning, the dashboard
will display the message
"
Please check high beam
"
.
Caution
●
High beam can dazzle the driver of oncoming car,
so please use it properly.
Turning Assistance Light
When turning the steering wheel to turn, it will light up the
corresponding side turning assistance lamp separately to
assist the moving vehicle to illuminate the blind area of the
curved road, and after the steering wheel returns to the center,
the single-side turning assistance light turns off.
To Next Page
