Xray T3 2012 - Suspension Arm Options and Setup; Rear Suspension Arm Options; Front Suspension Arm Options

13






901308
SB M3x8
901408
SB M4x8
901308
SB M3x8
901408
SB M4x8

 
 

 
 

 
 

 
 
903306
SFH M3x6
 




3. FRONT & REAR SUSPENSION
3mm
2.0mm
3mm
4x8mm
3x8mm
L=R


L=R
COMPLETED ASSEMBLY
3x8mm
4x8mm
COMPLETED ASSEMBLY

L=R
2.2mm
L=R
 - more rear traction
 - more stable
Use the inner position for initial setting.

 - more rear traction (recommended for low-, medium-traction)
- more steering (recommended for high-traction)
 - more steering (recommended for low-, medium-traction)
- more stable, easier to drive (recommended for high-traction)

 - more steering
 - more stable
Use the outer position for initial setting.

Optional shims may be used for raising roll center. Use 3x7
shims with thicknesses between 0.1–0.5mm

Optional shims may be used for raising roll center. Use 3x7
shims with thicknesses between 0.1–0.5mm