XS Instruments COND 7 Plus - Page 19

19
7+Series Version 2.0
P1.1 Select pH standard solution
P1.4 Select resolution
P1.5 Restore to factory setting
P1.6 Set stability criteria
P1.7 Temperature calibration
P2.1 Select electrode constant
P2.2 Select conductivity standard solution
P2.5 Select reference temp.
P2.6 Adjust temperature
compensation coefficient
P2.8 Restore to factory setup
P2.9 Temperature calibration
P6.1 Select temperature unit
P6.6 Parameters selection
P6.8 Automatic power-off setup
Submenu of pH parameter setting
P3.1 Adjust TDS factor
Main menu of parameter setting
Submenu of conductivity parameter setting
Submenu of TDS parameter setting
Submenu of basic parameter setting