Need help?Do you have a question about the XTA DP224 and is the answer not in the manual?
General| Type | Digital Signal Processor |
|---|---|
| Outputs | 4 x XLR |
| Crossover | Yes |
| Dynamic Range | >110 dB |
| Signal to Noise Ratio | >110 dB |
| Input Impedance | >10 kOhms |
| Output Impedance | <100 Ohms |
| Sampling Rate | 96kHz |
| Bit Depth | 24-bit |
| Inputs | 2 x XLR |
| Delay | Yes |
| Limiter | Yes |
| Power Supply | 50/60Hz |
| Control Interface | Ethernet |
| Dimensions | 482 mm x 44 mm x 300 mm |
| Channels | 2 input, 4 output |
| Frequency Response | 20Hz - 20kHz |
Guide to navigating unit functions and parameters.
Managing input settings and configurations.
Crossover design, unit locking, and system settings.
Description of the display and navigation buttons.
Steps for initial configuration of the unit.
How to modify signal gain for inputs and outputs.
Adjusting frequency, Q, and gain for equalization.
Configuring output limiter attack, release, and threshold.
Recall, store, PC card operations, and memory erase.
Load, design, store, and erase crossover memories.
User specific locking, password entry, and lock types.
Status, display contrast, LED brightness, updates, and cloning.
To Next Page
