Need help?Do you have a question about the XTA DP6i and is the answer not in the manual?
Manual detailing operation and features of the DP6i unit.
Essential parameters and values for operating the DP6i unit.
Highlights audio quality, flexible format, EQ, limiters, and connectivity options.
Covers Select Key, Adjust Keys, LED Display, Metering, Mute Key, and Recall Keys.
Details power, MIDI IN, RS485, and Audio In-Out connections on the rear panel.
Steps for powering on, initial configuration, and interface selection for the DP6i.
Details RS232, RS485, MIDI, and GPI interfaces for DP6i remote control and memory recall.
Diagrams and explanations for 2x2, 2x3, 4x2, 5x1, and 6-way DP6i configurations.
Specifies how AES/EBU digital signals are routed through DP6i's XLR connectors.
Covers operating level, grounding, filter slopes, time alignment, and output limiters.
Table for converting dB limiter thresholds to Vrms values.
Default crossover frequency settings and names for all DP6i configurations.
Details on the GPI interface for remote memory recall and its installation.
Manual detailing operation and features of the DP6i unit.
Essential parameters and values for operating the DP6i unit.
Highlights audio quality, flexible format, EQ, limiters, and connectivity options.
Covers Select Key, Adjust Keys, LED Display, Metering, Mute Key, and Recall Keys.
Details power, MIDI IN, RS485, and Audio In-Out connections on the rear panel.
Steps for powering on, initial configuration, and interface selection for the DP6i.
Details RS232, RS485, MIDI, and GPI interfaces for DP6i remote control and memory recall.
Diagrams and explanations for 2x2, 2x3, 4x2, 5x1, and 6-way DP6i configurations.
Specifies how AES/EBU digital signals are routed through DP6i's XLR connectors.
Covers operating level, grounding, filter slopes, time alignment, and output limiters.
Table for converting dB limiter thresholds to Vrms values.
Default crossover frequency settings and names for all DP6i configurations.
Details on the GPI interface for remote memory recall and its installation.
General| Type | Digital Signal Processor |
|---|---|
| Output Channels | 6 |
| A/D and D/A Conversion | 24-bit |
| Sample Rate | 48kHz |
| Sampling Frequency | 48 kHz |
| Outputs | 6 x XLR |
| Input Impedance | 10 kΩ balanced |
| Frequency Response | 20 Hz - 20 kHz |
| THD+N | <0.002% |
| Filter Types | Parametric, Shelving |
| Control Interface | Ethernet, RS485 |
| Remote Control | PC software |
| Dynamic Processing | Compressor, limiter |
To Next Page
