EasyManuals Logo

Xtool D1 User Manual

Xtool D1
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
8. Use the motor cable to connect the motor on the left plate to the main control board.
Note: Press the connectors of the motor cable into place to prevent poor contact.

Table of Contents

Other manuals for Xtool D1

Preview: Quick Start Guide
Quick Start Guide5 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xtool D1 and is the answer not in the manual?

Xtool D1 Specifications

General IconGeneral
Working Current5A
Laser Power10W
Engraving Speed10000mm/min
Supported MaterialsWood, Leather, Paper, Plastic
Software CompatibilityLightBurn
ConnectivityUSB, Wi-Fi
Focus AdjustmentFixed focus laser (adjust focus by adjusting the height of the laser)

Related product manuals