Xtrails VESDA-E VEP-A00 - Page 55

VESDA-EVEP-A00-P Product Guide
www.xtralis.com 47
2. Enter a unique name for the Connection or accept the pre-generated name, then select Finish
(Figure5-4).
Figure5-4: Enter a Connection Name
Adding an Ethernet connection
1. Select Ethernet, then select Next (Figure5-5).
Figure5-5: Select Ethernet
2. Enter the IPaddress of the detector. Enter the password that has been set for Ethernet authentication.
Select Next (Figure5-6).
Note: The IP address and password of the detector is configured in the Ethernet options section
during initial setup with a USB connection. Refer to Section 5.5.3 on page 56 or 1.0.1 on page
1 for further information.
Figure5-6: Enter IPAddress