Need help?Do you have a question about the Xtralis ICAM IFT and is the answer not in the manual?
General| Number of Sampling Holes | Up to 100 |
|---|---|
| Power Supply | 24V DC |
| IP Rating | IP30 |
| Technology | Laser Based |
| Detection Principle | Aspirating Smoke Detection (ASD) |
| Detection Range | 0.001% to 20% obs/m |
| Alarm Sensitivity | Configurable |
| Alarm Threshold | Configurable |
| Sampling | Aspirated via pipe network |
| Pipe Length | Up to 100 meters per pipe |
| Response Time | Typically less than 60 seconds |
| Operating Temperature | -10°C to +55°C |
| Approvals | EN 54-20 |
| Communication | RS-485 |
| Weight | 2.5 kg |
Gathering site information and regulatory forms before visiting the customer site.
Checking cables, powering up the system, and performing a preliminary system check on site.
Configuring the system, setting thresholds, and recording settings and specifications.
Performing pipe network integrity, relay function, detector, ancillary device, and performance tests.
Completing forms, attachments, and forwarding copies to relevant persons for system handover.
Lists essential documents and tools required before starting the commissioning process.
Specifies client and site details to be completed in the ICAM commissioning forms.
Describes tasks to be performed once the commissioning engineer is physically at the site.
Explains key functions for configuring IFT detectors using a connected display panel and access codes.
Details how to configure ILS detectors via the user interface or Xtralis VSC software.
Explains how to configure IAS detectors through the user interface panel or Xtralis VSC software.
Details smoke test types, environmental considerations, and recording procedures for performance testing.
Explains how to test IFT detector outputs using a diagnostic test via the TEST OUTPUTS menu.
Details recording test results on ICAM commissioning forms and forwarding them to relevant parties.
To Next Page