Need help?Do you have a question about the Xtralis ICAM ILS-2 and is the answer not in the manual?
General| Brand | Xtralis |
|---|---|
| Model | ICAM ILS-2 |
| Category | Smoke Alarm |
| Detection Principle | Laser light scattering |
| IP Rating | IP30 |
| Alarm Sensitivity Range | 0.001 to 20% obscuration per meter |
| Power Supply | 18-30 VDC |
| Operating Temperature | -10°C to +55°C |
| Humidity Range | 10% to 95% RH non-condensing |
| Communication Interface | RS-485 |
| Alarm Relays | 2 programmable relays |
| Certifications | EN 54-20 |
| Air Sampling Points | 2 sampling points |
Details on how to securely install the detector unit onto a mounting surface, including hole marking and fastening.
Explains the procedure for connecting external wires to the unit's main circuit board terminals.
Details the required Red ABS pipe specifications for EN54-20 compliance, including material and diameter.
Describes common methods for securing the sampling pipe, such as pipe clips and tie wraps.
Guidance on using swept bends, not sharp elbows, to avoid pressure loss and maintain response times.
Information on the end cap for pipe termination, which may serve as a sampling point if drilled.
Instructions on drilling sampling holes, including placement, angle, and cleaning to ensure performance.
Guidance on managing the unit's exhaust, including when to return it to the protected area or keep it open.
Details the single stage dust particle filter used for sampled air and its recommended replacement schedule.
Describes double pipe configuration limits and requirements for EN54-20 compliance using ASPIRE design tool.
Explanation of LEDs and bargraph indicators for system status, smoke level, and airflow speed.
Describes how to operate the unit using programming buttons for functions like reset, isolate, fan speed, and sensitivity.
Details setting Fan Speed, Flow Limits, and Flow Sensitivity for optimal installation and performance.
To Next Page