Xtralis VESDA-E VES-A10-P - Page 65

VESDA-EVES-A10-P Product Guide
www.xtralis.com 59
5.5.2 VESDAnet Options
The VESDAnet options provide the ability to control network data transmission behaviour for VESDAnet
connections.
Note: Refer to Section 5.6 for the default settings.
Figure5-13: VESDAnet Communications Options
The Communications configuration options are as follows:
l Preferred Port: The preferred VESDAnet port to be used to transmit network data from this device. The
non-preferred port is used if for some reason transmissions on the preferred port fail. For best
performance in large networks, this setting should be randomly distributed between connected devices.
l Loop Open Ended on This Device: This should be checked if the network has been wired so either
VESDAnet port A or VESDAnet B is not connected on this detector. (Xtralis recommends that
VESDAnet ports A and B are always connected so this option should normally not be checked.).
l Minimum interval between status events: The minimum time interval between status updates for the
selected detector.