EasyManuals Logo

XVision H.264 Video Compression High Definition Digital Video Recorder User Manual

XVision H.264 Video Compression High Definition Digital Video Recorder
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
103
APPENDIX: How to connect network
A. How to set IP address of the DVR and open TCP port of the router?
The port forwarding is dependent on the brand and model of the router. The port forwarding is required to
allow access to the DVR beyond a router.
Connect network cable between DVR and Router or ADSL modem.
1. Default network setting on DVR are
- Port: 5445
- WEB Port : 80
- Network : DHCP
2. From PC connected in the same Router, find IP address, Gateway, and Subnet mask by
IPCONFIG command in command prompt.
3. But if IP is something else like 192.168.x.xxx., you should change IP address, Subnet, Gateway on
the DVR. Go to SETUP>NETWORK>LAN of the DVR and change the IP settings to be like IP:
192.168.XXX.XXX and Gateway: 192.168.XXX.XXX. (Refer to the user’s manual of Router.)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the XVision H.264 Video Compression High Definition Digital Video Recorder and is the answer not in the manual?

XVision H.264 Video Compression High Definition Digital Video Recorder Specifications

General IconGeneral
BrandXVision
ModelH.264 Video Compression High Definition Digital Video Recorder
CategoryDVR
LanguageEnglish

Related product manuals