Need help?Do you have a question about the Xylem Bell & Gossett PL Series and is the answer not in the manual?
General| Series | PL |
|---|---|
| Seal | Mechanical seal |
| Maximum Flow | Varies by model |
| Maximum Head | Varies by model |
| Temperature Range | 250°F (121°C) |
| Motor | TEFC, ODP, or Explosion Proof |
| Construction | Cast Iron |
| Connection Type | Flanged |
| Max Flow Rate | 3000 GPM |
| Max Head | Varies by model |
| Max Temperature | 250°F (121°C) |
| Voltage | 208-230V, 460V |
| Frequency | 60 Hz |
Explains the use of the safety alert symbol to draw attention to safety-related instructions.
Details the Series PL Booster Pump features: permanently lubricated bearings, permanent split capacitor motor.
Specifies maximum working pressure, operating temperature, and electrical ratings for the pump.
Identifies the Series PL Booster Pump's use in hydronic and solar systems, excluding pools/marine areas.
Covers hazards related to excessive system pressure and volumetric expansion.
Addresses electrical shock and grounding hazards, requiring qualified electricians and proper grounding.
Warns about extreme temperature hazards, requiring guarding or insulation.
Provides step-by-step instructions for safely removing the pump from an installed system.
Offers guidance on pump placement, service valves, flange installation, and minimizing pipe strain.
Details the process for making electrical connections, including conduit box and wire suitability.
Instructs on cleaning, draining, and refilling closed heating/cooling systems, and maintaining pH.
Outlines startup steps, emphasizing filling the system, venting air, and avoiding running the pump dry.
Explains permissible pump orientations (up, down, horizontal) and conduit box positioning.
Provides detailed steps for disassembling, inspecting, and reassembling the mechanical seal.
Recommends regular inspections to check for potential problems and leakage.
To Next Page