What to do if my Xylem Flygt 3060 does not start?
If your Xylem Water Pump isn't starting, ensure the main power switch is on and that there's control voltage reaching the starting equipment. Inspect the fuses to confirm they are intact, have power, and are properly secured. Verify voltage in all supply line phases and check for any tripped overload protection. Lastly, examine the motor cable for damage.
Why my Xylem Water Pump does not start automatically?
If your Xylem Water Pump doesn't automatically start, but starts manually, check the start level regulator for proper function. Clean or replace it if needed. Ensure all connections are secure, and inspect the relay and contactor coils for damage. Verify the control switch (Man/Auto) makes contact in both positions. Also, check the control circuit and its functions.
What to do if Xylem Flygt 3060 Water Pump does not start and an alarm signal has been triggered?
If an alarm signal is triggered on the control panel of your Xylem Water Pump, ensure that the impeller rotates freely and the sensor indicators do not show an alarm. Also, make sure the overload protection hasn't tripped. If the problem continues, contact your local sales and service representative.
General| Type | Submersible pump |
|---|---|
| Material | Cast iron |
| Protection Class | IP68 |
| Seal Type | Mechanical Seal |
| Frequency | 50 Hz |
To Next Page