Fill with oil
The oil should be a medical white oil of paraffin type that fulfills FDA 172.878 (a) and
viscosity close to VG32. Examples of suitable oil types are the following:
• Statoil MedicWay 32
™
• BP Enerpar M 004
™
• Shell Ondina 927
™
• Shell Ondina X430
™
1. Replace the O-rings of the oil plugs.
2. Refit an oil plug in the hole that faces downwards or is marked "oil out", and tighten.
Tightening torque: 10-40 Nm (7.5-29.5 ft-lb)
3. Fill with oil through the hole on the opposite side or the hole marked "oil in".
If the hole is marked "oil in", slightly tilt the pump and lower it again in order to fill the
pump with the correct quantity.
Quantity: approximately 1.0 L (1.1 qt).
4. Refit the oil plug and tighten.
Tightening torque: 10-40 Nm (7.5-29.5 ft-lb).
6.4 Service the pump
Type of
maintenance
Purpose Inspection interval
Initial inspection A Xylem-authorized personnel checks the pump condition.
From the results, the personnel recommends the intervals
for the periodical inspection and overhaul for the
installation.
Within the first year of operation.
6 Maintenance
46 Flygt 3102 Installation, Operation, and Maintenance Manual
To Next Page
Loading...
Need help?
General
