EN 10
Starting Projector
1. Press the power key on the remote controller or projector, the indicator light will turn blue.
2. Use the focus function of the projector to get the best image performance.(If it is still
blurry, please try to adjust the projection distance.)
3. Use the keystone function of the projector to get a rectangle projection screen.
4. Connect the external device (Smart phone, iPad, Fire TV, TV box, DVD player, Computer,
etc.) in the corresponding interfaces of the projector, please be sure to select the
corresponding source. If you do not select the correct source, the projector will not be able
to detect the signal.
5. Select the " " menu,enter the [ Common ], then you can select the option [ Language ] to
set your preferred language.
Image Adjustment
When using the projector for the first time, it normally displays an unclear image. This is due
to the lens being out of focus or the incorrect trapezoid setting.
Please follow the below steps to correct:
1. Focus Adjustment
Focus Ring
Rotate the focus ring or lens slowly. At the same time, check the focus point carefully. The
best focus point for the lens would be where the image most clear.
Note: If it is still blurry, please try to adjust the projection distance.
To Next Page
Loading...
Need help?
General
