Yaesu FT3DR Advanced Manual

10
New Two-Tone CTCSS Pager Function
When using FT3DR/DE transceivers with a group of friends, setting the Two-Tone
CTCSS personal codes allows calling just the specific stations. Even when the person
who is called is not near the transceiver, the information on the LCD indicates that a call
was received.
The new two-tone CTCSS pager feature does not operate in digital mode. Touch [MODE] to
change the communication mode to Analog FM mode or turn the AMS function ON.
Using the Pager Function
1. Touch [F MW]

[SQTYP
]
.
If [SQTYP] is not displayed, touch [FWD →] to display [SQTYP] and then touch it.
2. Rotate the DIAL knob to select the “PAGER”.
3. Press the PTT switch to save the setting and return to normal operation.
Setting the Code for Your Station
Set the “pager code” to be called by other stations.
1. Activate the pager function by referring to “Using the pager function” above.
2. Touch [F MW]

[CODE
]
.
If [CODE] is not displayed, touch [FWD →] to display [CODE] and then touch it.
3. Rotate the DIAL knob to select “CODE-RX”.
6 PAGER
ANS-BACK: OFF
CODE-RX : 05 47
CODE-TX : 05 47
4. Press the [DISP] key to move the “
u
” icon to the first
element of the code.
Rotate the DIAL knob to select the first element of the
code from 1 to 50.
6 PAGER
ANS-BACK: OFF
CODE-RX : 05 47
CODE-TX : 05 47
5. Press the [DISP] key to move the “
u
” icon to the
second element of the code.
Rotate the DIAL knob to select the second element of
the code from 1 to 50.
The same code cannot be use for both elements.
6 PAGER
ANS-BACK: OFF
CODE-RX : 05 47
CODE-TX : 05 47
6. Press the PTT switch to save the setting and return to
normal operation.

Yaesu FT3DR Specifications

General

Brand	Yaesu
Model	FT3DR
Category	Transceiver
Language	English