114
Convenient Functions
CommunicatingwithSpecifiedPartnerStations
Notificationofanincomingcallfromapartnerstationusingthebell
When communicating using the tone squelch, DCS or pager, a bell (beep) can be
sounded to provide notification that a signal has been received from a partner station.
1 Press for one second or longer
The set-up menu will be displayed.
2 Touch [SIGNALING]
The menu list will be displayed.
$#%-
$#%-
6:4:
5'672/'07
4'5'6
%.10'
%10(+)9Ჰ4'5
5%#0
&+52.#;
5+) 0#.+0)
#245 126+10
5&%#4&
/'/14;
#
%#..5+) 0
3 Touch [7BELLRINGER] to select the length of the
bell ring
The bell ring changes as follows each time it is
touched.
“OFF” “1 time” “3 times” “5 times” “8 times”
“CONTINUOUS”
Tip Factory default value: OFF
$#%-
$#%-
2#)'4%1&'
&6/(/'/14;
$'..4+0)'4
24)4'8610'
5+) 0#.+0)
1((
*\
ᲸᲸᲹᲽ
Ჽ
Ჾ
Ჿ
Ż
Ż
4 Press for one second or longer
The bell ring will be set and the display will return to the previous screen.
Tip The display can also be returned to the previous screen by touching [BACK] twice.
Othersquelchfunctions
● Reversetone
Touch [SQL] in the function menu to display “T-REV”.
This is a communication method whereby a tone signal is sent out when there is no
sound. When there is a sound, the tone signal will disappear.
● UserProgrammedReverseCTCSSDecoder
Touch [SQL] in the function menu to display “PRGM”.
The user programmable Reverse CTCSS Decoder will mute your FTM-400XDR/DE
receiver when it receives a signal containing a CTCSS tone matching your programmed
tone. The tone signal frequency can be set at 100 Hz intervals between 300 Hz and
3000 Hz using [SIGNALING]→[6PRGREVTONE] in the set-up menu.
To Next Page
Loading...
Need help?
General
