Yale Assure Lock YRD420 User Manual

Part of ASSA ABLOYP/N YRD400-KD-0022 Rev ATrusted every day
4
Check Door:
Tear off the Door Checker page of this guide and follow
instructions to verify your door measurements and make any
needed adjustments.
Note: There are some cases where existing holes cannot be
adjusted to be compatible.
New Door:
Tear off the Template page of this guide and use either 21/8" or
11/2" template to prepare a new door that has no holes or to
adjust existing holes to be compatible.
Check Door Measurements and Adjust If Needed
2
Check Your Door Guide
1/4
1/8 3/8 5/8
3/4
7/8
0123
1/4
1/8 3/8 5/8
3/4
7/8
1/4
1/8 3/8 5/8
3/4
7/8
1/21/2 1/2
I
B
Blue
C
Black
D
Silver
EF
45
1/21/2
1/4 3/4 1/41/4
1/2
1/8 3/8 5/8 7/8 1/8 3/8 5/8 1/8 3/8
A
A. 2" Minimum clearance between top of
existing lever/knob rose (trim) and center
of deadbolt hole.
2" tolerance for optimal Door Sense
location.
B. 1-3/8" Door Thickness se blue Screw; u
Set B (shortest set).
C. 1-3/8" - 1-3/4" DoorThickness; use black
Screw Set C.
D.2" - 2-1/4" Door Thickness; use
silver Screw Set D (longest set).
E; u. 2-3/8" Backset se Out of Box latch
setting.
F. 2-3/4" Backset; adjust latch setting.
Instructions on how to adjust the latch
are included in manual.
G. 1-1/2" Face Bore Diameter. Instructions
on how to remove the black adapter from
the lock are included in manual.
1-1/2"tolerance from inside door frame
edgefor optimal DoorSense location.
H. 2-1/8" Face Bore Diameter.
I. Edge Bore Diameter and Depth.
Cross Bore Diameter.
H
3/4
7/8
67
1/2
1/4 3/4
1/8 3/8 5/8 7/8
3/4
7/85/8
CAUTION:
If printed from electronic file,
Measure ruler to check scale.
set print scale to 1:1.
G
To ensure a successful installation, measure each aspect of your door and frame, as shown in panels (left side of sheet) using
the ruler abo ve. Make sure all of your dimensions are a . See letter definitions below for guidance.
FO LD OV ER DO OR E DGE
Centerline
Center
of 1" (25mm)
hole through
edge of door
For 1-3/8"
35mm()
Thick Door
2-3/8" 60mm Backset()
2-3/4"70mm Backset()
For 1-3/"4
mm(44.5 )
Thick Door
Center
of 2-1/8" (54mm)
hole through face
of door
Center
of 2-1/8" (54mm)
hole through face
of door
Center
of 1" (25mm)
hole through
edge of door
Door
CAUTION:
If printed from electronic file,
Measurea dimension
to check scale.
set print scale to 1:1

Yale Assure Lock YRD420 Specifications

General

Brand	Yale
Model	Assure Lock YRD420
Category	Locks
Language	English