Control unit
Plug the power adaptor
into the mains supply wall
socket and the other end
into the control unit.
• The batteries in the
control unit are
rechargeable and act as
a back-up in case of
power failure. They are
charged automatically
by the mains supply. If the mains supply is
disconnected, an AC Power Fail message will
be displayed and the LCD back light will be
switched off.
•From new, the batteries need 72 hours to
charge completely.
6
Unpack all the parts onto a table top
The easiest way to get to know the system and get it up and running quickly is to get
all the devices and accessories programmed on a table top before locating and mounting them.
2
Siren
WARNING: The siren is very loud, be
prepared! Take care not to activate the siren
unnecessarily.
1 Remove the cover by unscrewing the single
screw located at the bottom.
2 Remove the covers of the two internal
compartments.
3 Insert the four D batteries as shown.
There is a slight pause while the unit initialises.
The siren will then beep and the LEDs flash.
Tamper
switch
Jumper
switches
Fixing holes
x 4
To Next Page
Loading...
Need help?
General
