15
P/N -220- - Rev FAYRD INST FUL
When lock is reset to factory defaults all user codes
(including the Master code*) are deleted and allPIN
programming features are reset to original default
settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior escutcheon to access the
reset button.
3. The reset button (see image at right) is located
above the cable connector.PCB
4. While pressing the reset button (minimum of 3
seconds) reinstall batteries. Release reset button.
5. Replace battery cover.
Upon reset, Master Code creation is the onlyPIN
option available and must be performed prior to any
other programming of the lock.
Registration required*
Wrong Code Entry Limit
5 Times
One Touch Locking
Enabled
Inside Indicator Light
Disabled (Off)
Interior Escutcheon
Factory Settings
Resetting Lock to Factory Default
Settings
Factory Setting
Master CodePIN
Automatic Re-lock
Disabled
Volume Setting
Enabled (Low)
Automatic Re-lock Time
30 Seconds
Shutdown Time 60 Seconds
*The Master code must be registered prior to any other programming ofPIN
the lock.
To Next Page
Loading...
