Yale Real Living YRD220

Yale Real Living Z Module
®®
-Wave
Installation and Programming Instructions
Installing the Z Module-Wave
®
It is recommended that lock is programmed through the centralized user interface ( orPC
hand-held device) to ensure communication between the lock and the controller unit. The
network controller first needs to be in enrollment or exclusion mode for the lock to be
enrolled or unenrolled from network.
To Enroll the Module:
• Enter the 4-8 digit Master code followed by the key.PIN
• Press the key followed by the key.
• Press the key followed by the key.
To Unenroll the Module:
• Enter the 4-8 digit Master code followed by the key.PIN
• Press the key followed by the key.
• Press the key followed by the key.
Enrolling/Unenrolling the Network Module:
IMPORTANT: the batteries be removed priormust
to removing and/or inserting the network module:
• Remove battery cover.
• Remove batteries.
• Remove and/or insert network module.
• Reinstall batteries.
• Replace cover.
P/N 200- - - Rev CAYR ZW INSTAL FUL
®