To Next Page

To Previous Page

142 Chapter 12—Monitoring & Talkback

02R96 Version 2—Owner’s Manual

Using Talkback

The Talkback function distributes the Talkback mic signal to the Studio Monitor Outs and

any Slot or Omni Outputs speciﬁed on the Talkback Setup page.

The TALKBACK LEVEL control sets the level of the built-in talkback micro-

phone.

The [TALKBACK] button has two modes of operation: If it’s pressed once (i.e.,

for less than 300 ms), the Talkback function is turned on and remains on when

the button is released. This is Latched mode (this mode can be disabled on the

Talkback Setup page). If it’s pressed and held for longer, the Talkback function is

turned on, but turns off when the button is released. This is Unlatched mode.

The [TALKBACK] button indicator ﬂashes while the Talkback function is active.

Talkback Setup

1 Use the MONITOR [DISPLAY] button to locate the Talkback Setup page.

2 Use the cursor buttons to select the parameters, and use the Parameter

wheel, INC/DEC buttons, and [ENTER] button to set them.

OUTPUT ASSIGN: These buttons are used to assign the Talkback mic signal to Slot and

Omni Outputs.

STUDIO MONITOR: This allows you to select the Talkback mic signal as the Studio

Monitor source.

TALKBACK DIMMER LEVEL: When the Talkback function is active, this determines the

amount of attenuation applied to sound sources assigned to the Studio Monitors and

selected for Talkback.

USE AD IN x AS TALKBACK: This allows you to select an AD Input as the Talkback sig-

nal source. Use the check box to turn this option on and off, and use the number parameter

to specify the number of the AD Input. The signal from the speciﬁed AD Input is mixed

with the Talkback mic signal. Turn down the TALKBACK LEVEL if you do not want to use

the Talkback mic.

NEVER LATCH TALKBACK: This options allows you to disable latching for the Talkback

function.

010

TALKBACK LEVEL

TALKBACK

Yamaha 02R96 User Manual

Other manuals for Yamaha 02R96