72 Chapter 6—Input & Output Patching
02R96 Version 2—Owner’s Manual
Patching with the Encoders
The following patches can be made by using the Encoders: Input Channel Inputs, Insert
Outs, Insert Ins, and Direct Outs.
1 Assign one of the above parameters to an Encoder ASSIGN button, as
explained on page 51.
2 Press the ASSIGN button to which you assigned the patch parameter.
3 Use the Encoders to select ports, and press the Encoder push switches to set
them.
The coresponding Patch page appears when an Encoder is operated. If you operate another
Encoder, the selection is cancelled and the patch is left unchanged.
To Next Page
Loading...
