BRAKE FLUID LEVEL INSPECTION
3. Inspect:
● Brake fluid level
Refer to “BRAKE FLUID LEVEL INSPEC-
TION” section.
4. Check:
● Brake pedal operation
A softy or spongy feeling → Bleed brake
system.
Refer to “BRAKE SYSTEM AIR BLEED-
ING” section.
BRAKE FLUID LEVEL INSPECTION
1. Place the brake master cylinder (reservoir
tank) so that its top is in a horizontal posi-
tion.
2. Inspect:
● Brake fluid level
Fluid at lower level a → Fill up.
È
Front
É
Rear
WARNING
●
Use only designated quality brake fluid to
avoid poor brake performance.
●
Refill with same type and brand of brake
fluid; mixing fluids could result in poor
brake performance.
●
Be sure that water or other contaminants
do not enter master cylinder when refill-
ing.
●
Clean up spilled fluid immediately to
avoid erosion of painted surfaces or plas-
tic parts.
● Install the brake caliper 0 and tighten the
pad pins A.
T
R
.
.
Bolt (brake caliper):
23 Nm (2.3 m • kg, 17 ft • lb)
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)
NOTE:
Apply the LOCTITE
®
on the bolt (brake cali-
per rear side).
Recommended brake fluid:
DOT #4
5PA30460
È
5PA30470
É
To Next Page
Loading...
Need help?
General
