Yamaha 20C - Inspecting and Replacing Anode

4-21
To clean the fuel tank:
1) Empty the fuel tank into an approved
gasoline (petrol) container.
2) Pour a small amount of suitable sol-
vent in the tank. Reinstall the cap and
shake the tank. Drain the solvent
completely.
To clean the fuel filter:
1) Remove the screws holding the fuel
meter assembly. Pull the assembly
out of the tank.
2) Clean the filter (located on the end of
the suction pipe) in a suitable clean-
ing solvent. Allow the filter to dry.
3) Replace the gasket with a new one.
Reinstall the fuel meter assembly and
tighten the screws firmly.
GB
902054
604024
604014
20/25D
25V/30
EML24010
INSPECTING AND REPLACING
ANODE
Yamaha outboard motor is protected
from corrosion by a sacrificial anode(s).
Check the anode periodically. Remove the
scales from surfaces of the anode.
For the replacement of the anode, consult
a Yamaha dealer.
cC
Do not paint the anode, for this would
render it ineffective.
61R-9-73-4B (GB,F,ES) 5/9/00 10:35 AM Page 20